Page History

...

The Access Point defaults to being a DHCP server on a private subnet. For configuration access, simply connect a PC with a cross-over cable and make the PC a DHCP client. After connecting, the client will have an IP address in the 172.23.56.0/24 network. For configuration access, point your PC's browser to https://172.23.56.254^{Image Removed}

A wizard will ask you basic questions about your intended configuration which are non eduroam-specific. Please complete the wizard by answering all the questions. If you changed the IP address of the Access Point with the wizard, re-connect to the Access Point on its new address after finishing the wizard.

...

B.2.2 NTP setup (confederation requirement: reliable timing source)

...

The Access point needs to be synchronised with a NTP or SNTP time server. There was an opportunity to set this up in the initial wizard, but let's verify if the settings are correct. Click on "Configuration" -> "Date & Time" -> "General". You should see the following menu:
Image Added

     1. Verify that the correct time zone and dayight saving time settings are set.
     2. Click on the "Synchronization" tab. You will see the following menu: Image Added

1. Verify that the radio button is set to "Synchronize to a time server ..."
2. The wizard suggested the server "pool.ntp.org" as a time source. This is a sane default choice, but if you have your own time server, you may want to set up that one instead. If so, 
3. Click on the link Time Server (NOT the menu Time Server on the left-hand side

...

1. )

...

1. .

...

1. Add

...

1. your

...

1. own server(s) as appropriate.

B.2.3 Logging

     1. Select Configuration>Log &Trace>Syslog and check the box Send information.
     2. Click Syslog clients>add.
     3. Add (minimum) localhost: IP 127.0.0.1, and activate all sources:
The logs that are collected with the localhost setting will show up under
Expert Configuration>Status>TCP-IP>Syslog.

...